I’ve never been able to get a clean first layer with this machine. I have given it a beacon probe and it just made it much faster to get the same problem to happen again. Where am I going wrong?
I’ve never been able to get a clean first layer with this machine. I have given it a beacon probe and it just made it much faster to get the same problem to happen again. Where am I going wrong?
0.2mm flatness is very flat for a 3D Printer bed, I don’t even know if I achieved that with the Nylock mod on my old Prusa. This simply looks like a bed adhesion problem, clean your bed well with dish soap and water and then rinse well and make sure you don’t toch the surface. Check the first layer height and bed temp as well.
I noticed something while printing. it doesnt have a bed mesh loaded when it prints. it saves the last mesh, but doesnt load it. why?