I was printing some ABS on my modified Anycubic I3 Mega overnight, when I awoke to this horror of a destroyed glass print bed…

Now the question remains, how to actually fix this? One part is still firmly attached to the Bed and I fear this may destroy the Bed even more.

And I obviously need a new Print bed, but I can’t find the exact replacement, so should I even get a replacement Ultrabase? I saw that there are magnetic PEI beds available, but I am unsure if it is worth the 80-100€ for this.

Edit: Since the glass is glued to the 1.5mm aluminium heater PCB (and I already had to resolder the broken off wires once) I was looking at complete replacements at first, which why the price is relatively high

  • CmdrShepard49@sh.itjust.works
    link
    fedilink
    English
    arrow-up
    2
    ·
    14 hours ago

    Just get the $25 magnetic sheet and PEI plate, and slap them both on there. If you do go the route of a new aluminum bed, you can heat this bed up to 80 or 90C and then peel the heat pad off of it and stick it onto your new bed. I did both these on my old Sidewinder X2 but didn’t notice much benefit to the aluminum bed (the OEM glass bed was slightly warped and concave), so I didn’t find it worth the money to be honest. I think it’s worth trying in stages since you’re not really out any money if you decide the simpler and cheaper solution doesn’t cut it.

    • Klajan@lemmy.zipOP
      link
      fedilink
      English
      arrow-up
      1
      ·
      7 hours ago

      Yes that was my idea, I already ordered a magnetic plate kit today and I can try this out first. Since the heater is an aluminum PCB directly glued to the glass I might just try to separate the glass from the PCB if the glass if sticking it on top doesn’t work out like I wanted