Fourth try on a print. Tried to add some adhesive to the bed to get it to stick better. Watched the first two layers and went to bed. Woke up to a printer on strike.
Fourth try on a print. Tried to add some adhesive to the bed to get it to stick better. Watched the first two layers and went to bed. Woke up to a printer on strike.
It might not be cheap (or maybe it is, I dunno) but replacement parts are available. https://eu.store.bambulab.com/en-se/collections/spare-parts-for-a1-series
There is also a chance that they can rescue it without replacing anything, but it will very likely be quite time consuming and they will have to be careful to not damage anything.
This also doesn’t look too bad.
These nozzles are cheap. And it shouldn’t be very difficult fix this one if you have a heat gun. The hard part will be to get at the latch that holds the the nozzle assembly in the extruder. That’s small, fiddly, and delicate part that there is a good chance of breaking.
So while you are ordering that spare heater assembly, ($20US) you might as well get a new nozzle too, ($10US).