cm0002@lemmy.world to 3DPrinting@lemmy.worldEnglish · 2 months agoPrintGuard Is a New Open Source 3D Printing Failure Detector That Runs on the Edgewww.hackster.ioexternal-linkmessage-square12fedilinkarrow-up151arrow-down12
arrow-up149arrow-down1external-linkPrintGuard Is a New Open Source 3D Printing Failure Detector That Runs on the Edgewww.hackster.iocm0002@lemmy.world to 3DPrinting@lemmy.worldEnglish · 2 months agomessage-square12fedilink
minus-squareAppearanceBoring9229@sh.itjust.workslinkfedilinkEnglisharrow-up1·2 months agoDown anyone know of it works with belt printers? I had it, but it kept restarting some prints that were fine and never detected a failure :(
Down anyone know of it works with belt printers? I had it, but it kept restarting some prints that were fine and never detected a failure :(